How to build your bendapal

     After the body parts have all been painted and the eyes and wings jewels have been placed and everything has dried, you are ready to assemble your BendaPal. You will first need to glue only one side of your colored pipe cleaners into the correct holes. (Try to remove as much lose fuzz with your fingers from the ends of your pipe cleaners to expose some of the wire that will be glued into the holes).

     Next you will put a dab of glue on each foot hole and put the foot pipe cleaner end at an angle into the hole and hold for a few seconds. Set aside. 

     Next you will put a dab of glue on the wing holes at the end of each wing and put the pipe cleaners in at an angle and hold for a few seconds. Set aside. 

     Next put a dab of glue on the paw holes and place the arm pipe cleaners in at an angle and hold a few seconds. Set aside.

     Last put a dab of glue on the bottom of the head hole and place the head pipe cleaner in the hole. Set aside and wait for about a few hours to dry. 

    Finally, put a dab of glue on the leg holes on the body and push the leg pipe cleaners in. 

     Turn the body sideways and put dab of glue on the body wing holes and push the wing pipe cleaners in, but leave some exposed so you can move the wings around. 

     Then turn the body facing you and put a dab of glue on the body arm holes and push the arms in half an inch (.05inch) with the paws facing down.

     Last put a dab of glue on the head hole at the top of the body and push the head pipe cleaner inside and leave space so you can move the head around.

             You are done and your BendaPal is complete! Enjoy